| The
Hoffmann X-15 bench-top routing machine is equipped with a
high speed router motor, located at the center of the machine.
The supplied 45 degree fence plate, which is guided in a keyway
in the machine table, is used to accurately position the material
on the table. The location of the dovetail slots for the Hoffmann
Keys is adjusted by simply moving this fence plate. Once set,
the plate is locked in place and the routing sequence can
begin.
The routing operation is started by
pulling the main lever. A hold down plate will be lowered
onto the workpiece, pressing it on the table and holding it
in place. Further pulling will lift the motor carriage up
until the preset cutting height is reached.
The motor is switched on automatically
by pulling the lever, it is switched off again when the lever
is returned to the home position.
Two springs in the lever mechanism
counteract the pull down force, which ensures controlled movements
throughout the routing process.
Output is approx. 16 routing strokes
per minute, which translates into 2 completely processed rectangular
frames. These numbers include material handling, but obviously
depend on routing depth, feed speed, material flow and operator
performance as well. The
supplied router bits are solid tungsten carbide, made to exacting
specifications. Depending on the routing depth and the material
to be routed, the useable cutter life is approx. 10,000 strokes.
Every machine is shipped with a tool kit and set-up jig, which
allows a router bit change in only minutes. Diamond cutters
are also available.
|
